Bespoke Iron Railings Fabricated to Your Architectural Drawings

t503-1

Custom iron railings fabrication means producing railings to your own architectural drawings, not to a catalogue design. Our Tel Aviv workshop measures on site, confirms a written specification with you, fabricates in-house and finishes the work before installation.

What Made-to-Drawing Railing Fabrication Means

When a project has a specific design language, the railing should follow the drawing rather than a standard profile. Made-to-drawing fabrication starts from your plans, sections and details, which we read against the actual building.

We work with architects and interior designers who need the railing to match a facade, a stair geometry or a balcony line. Your drawing stays the reference, and we translate it into workshop instructions.

How We Read Your Drawings

Before cutting any steel, we check the drawing for dimensions, fixing points, infill pattern and finish. Where the drawing and the site disagree, we raise the question with you in writing.

Plan and elevation dimensions cross-checked
Fixing details and substrate noted
Infill spacing and pattern confirmed
Finish and colour specified

On-Site Measurement and Written Specification

Drawings and buildings rarely match exactly, so we measure on site before fabrication. Our team records openings, levels and wall or slab conditions, then prepares a written specification for your approval.

The specification lists profiles, sections, connections, fixings and finishing so that everyone signs off on the same information. Changes are made before production, not after.

Fabrication in Our Tel Aviv Workshop

Iron railings are cut, bent, welded and assembled at our factory on Rival Street in Tel Aviv, a workshop run by the third generation of the family since 1945. Working in-house lets us control tolerances and keep the fabrication aligned with your drawing.

Each element is checked against the approved specification before it leaves the workshop, so site fitting goes smoothly.

Finishing: Galvanizing and Powder Coating

Exterior iron railings need protection against weather, so finishing is planned from the start. Hot-dip galvanizing gives a durable zinc base, and powder coating adds the colour your design calls for.

We discuss the environment, exposure and required colour with you during specification, so the finish suits the building and the drawing.

Installation and Standards

Our fitting process follows the approved drawing and the fixing details agreed in the specification. For balcony and stair railings, the Israeli railing standard SI 1142 applies in general terms; exact dimensional and load values are confirmed with your engineer rather than assumed from memory.

Please share your structural engineer's requirements early so they can be incorporated into the fabrication.

Frequently asked questions

Can you fabricate railings from my own architectural drawings?

Yes, fabrication follows your drawings and details. We check them against site measurements and confirm any differences with you in writing before production.

Do you measure on site before fabrication?

Yes, we measure openings, levels and substrate conditions on site. This gives a written specification that you approve before anything is cut.

How is the railing protected against weather?

Exterior iron is typically hot-dip galvanized and then powder coated in the colour you choose. The finish is agreed during the specification stage.

Who confirms the structural and safety values?

Exact dimensional and load values should be confirmed with your structural engineer. We refer to the Israeli railing standard SI 1142 in general terms and work to the engineer's requirements.

Common mistakes to avoid

A common error is sending drawings without site conditions, which leads to fit problems later. Leave finishing and fixing details undecided until after the railing is designed.

Our recommendation

Share your drawings together with the engineer's requirements and any site photos at the start. Early alignment on finish and fixings saves revisions and keeps the fabrication on track.

Summary

Made-to-drawing iron railings are fabricated from your plans after on-site measurement and written approval, then galvanized and powder coated in our Tel Aviv workshop.

השאירו פרטים ונחזור אליכם