Book an Aluminum Door Measurement Visit with Techno Kol Uzi

Why an On-Site Measurement Matters

Aluminum doors are made to measure, so the final result depends on the exact dimensions of your opening. Walls are rarely perfectly straight, floors may slope, and an older frame can be out of square. Measuring on site lets us see these conditions before anything is cut or welded.

A proper measurement also records the swing direction, the threshold height, the type of wall and the way the door will connect to the existing structure. These details prevent mistakes that would otherwise only appear during installation.

Who Should Book a Visit

Our measurement visits are designed for homeowners planning a new entrance or replacing an old door, and for contractors and architects who need a reliable specification for a project. Building committees and interior designers also book visits when several openings must match one design.

• Private homeowners renovating an apartment or house
• Contractors coordinating door installation with other trades
• Architects and designers who need accurate site data

How to Prepare Before the Visit

Send us a few clear photos of the opening, the surrounding wall and the existing door if there is one. A short note on which way the door should open, and whether the space is inside or outside, speeds up the visit considerably.

Clear the area around the opening if you can, and make sure someone who can make decisions is present. Having the floor finish already laid, or at least marked, helps us set the threshold correctly.

What Happens During the Visit

Our technician measures the width and height of the opening at several points, checks the verticality and levelness, and notes the condition of the frame. We discuss the design, the materials and the finish with you, including options for security and glazing.

After the visit you receive a written specification with the drawing and the agreed details. Nothing goes into production until you have reviewed and approved it.

From Measurement to Installation

Once the specification is approved, the door is manufactured in our factory on Rival Street in Tel Aviv. Aluminum and iron components are finished with the protection suited to the material, such as powder coating or hot-dip galvanizing where relevant.

Installation follows after production. We coordinate timing with you or your contractor so the opening is ready when the door arrives.

Tips for a Smooth Booking

Booking early helps, especially during busy renovation seasons. Tell us your preferred days and time window so we can plan the route efficiently. If several openings need measuring, list them all in one request so they can be covered in a single visit.

Keep your inquiry specific: mention the room, the approximate size and any safety or privacy requirements. This lets the technician bring the right questions and tools.

Frequently asked questions

How long does a measurement visit take?

The length depends on how many openings need measuring and how complex the site is. Our technician will give you an estimate when we confirm the appointment.

Do I need to be present during the measurement?

It is strongly recommended, so that decisions about swing direction, design and finish can be made on the spot. If you cannot attend, make sure someone authorized is available.

Will I receive anything in writing after the visit?

Yes. You receive a written specification and drawing that you review and approve before production starts.

Can a contractor book the visit for a client?

Yes. Contractors, architects and designers can book on behalf of their clients, and we will coordinate the details with the client directly when needed.

Common mistakes to avoid

Booking a visit only after the wall has been finished or the old door removed can make accurate measuring harder. Measure and confirm the opening before major works are completed.

Our recommendation

Measure the opening yourself roughly and send photos before the visit, but leave the final measurement to the technician on site. Confirm the swing direction and threshold height in writing before approving the specification.

Summary

Booking a measurement visit is the simplest way to get aluminum and iron doors that fit your opening exactly. A written specification approved before production keeps the project on track.

Related guides

• Requesting Samples of Door Finishes and Glass Options
• Order Custom Iron Doors for Your Home
• Warranty and After-Sales Support for Iron and Aluminum Doors
• Garage Access Doors: Iron and Aluminum Comparison
• Maintenance Schedule for Iron Doors in Coastal Climates
• Installing Iron Doors in Older Homes: Practical Considerations
• All models in this category