Can I Get a Handrail Cut to Exact Length in Tel Aviv?

t352-26

Yes, handrails can be manufactured and cut to the exact length you need, as long as the measurements are taken carefully on site. At Techno Kol Uzi, every railing is made to measure in our Tel Aviv workshop rather than cut from standard stock. Send us your measurements and photos, and we will confirm the final length before production begins.

Why Exact Length Matters for Handrails

A handrail that is even a few centimeters too short can leave a gap at the wall or stair post, while one that is too long may not fit between the mounting points. Cutting to exact length avoids both problems and gives a clean finish at each end.

Standard lengths rarely match real stairs, balconies and entrances, which is why custom cutting is the usual choice for private homes and building projects.

What You Need to Measure

Accurate measurements make the difference. Before contacting us, prepare the following:

The total length along the path the handrail will follow
The height of the rail from the stair nosing or floor
The position and spacing of wall brackets or posts
Whether the ends terminate at a wall, post or floor

Measure twice and note the units you used.

How the Custom Order Process Works

The process starts with an inquiry that includes photos and your rough measurements. We then visit the site to measure precisely, because walls are rarely perfectly straight or level.

Next we prepare a drawing and a written specification showing the lengths, profiles and fixings. You approve it, and only then does production start in our factory. This step protects you from ordering the wrong size.

Finishing and Protection After Cutting

Once cut and shaped, the handrail is finished to suit its location. Options include hot-dip galvanizing for strong outdoor protection and powder coating in a range of colors. Cut ends are cleaned and finished so they look neat and feel safe to touch.

Finishing is applied after cutting, so the final length is always the one you approved.

Installation and Fit Check

Installation follows production. Because each piece is made to your drawing, fitting is usually straightforward, but walls and stairs can still shift slightly from the plan. We recommend a final check on site before fixings are fully tightened.

If anything does not align, it is easier to adjust during installation than after the rail is permanently fixed.

When to Ask for a Site Visit

A site visit is worth requesting when the rail runs along a curved staircase, spans a long balcony, or connects to existing metalwork. Photos help, but on-site measurement gives the most reliable result.

For railings that must meet safety requirements, the Israeli railing standard SI 1142 applies. Exact height and load values should be confirmed with your engineer.

Frequently asked questions

Can you cut a handrail to any length?

Yes, we manufacture handrails to the length you measure and approve. The final size is confirmed in a drawing before production starts.

Do I need to measure the handrail myself?

You can send your own measurements, but we recommend an on-site measurement by our team for accuracy. This avoids errors from uneven walls or stairs.

What if my measurements change during the project?

Let us know as soon as possible, before production begins. Changes after manufacturing are harder to accommodate, so confirming the specification early is important.

Do custom handrails come in different finishes?

Yes. We offer hot-dip galvanizing and powder coating, so you can choose a finish that suits indoor or outdoor use and your design.

Common mistakes to avoid

The most common error is measuring only the straight run and forgetting the wall brackets or end connections. Always confirm where each end terminates before ordering.

Our recommendation

Take at least two measurements along the path and note any bends or wall irregularities, then request a site visit so we can verify the exact length before cutting.

Summary

Handrails can be cut to exact length through our made-to-measure process in Tel Aviv, starting with accurate measurements and an approved drawing.

השאירו פרטים ונחזור אליכם