Custom Fence Panel Sizes: What to Ask Before You Order

t301-35

When your opening or slope does not match standard panel widths, custom fence panel sizes are the practical solution. Before ordering, confirm the exact width, height, post positions, and how the fence will meet walls, gates, and uneven ground.

Why Standard Fence Panels Often Do Not Fit

Many outdoor spaces are not built to standard dimensions. Walls may be slightly out of square, gaps between pillars can vary, and sloped terrain changes the height from one end to the other. Ready-made panels rarely match these conditions, which is why made-to-measure work is common for homes and building committees in Israel.

Knowing where the standard limits fall helps you decide early whether a custom solution is needed.

Questions to Ask About Panel Width

Ask the manufacturer how panel width is measured: from center to center of posts, or from the inside of one post to the inside of the next. The difference can change the final fit by several centimeters.

Is the measurement taken on site, or from drawings?
Will the panel be cut to fit or built to a fixed width?
How are joints and overlaps handled at the posts?

Questions About Height and Sloped Ground

Height is not always uniform. On a slope, you may need stepped panels or panels that follow the incline. Ask whether the height is measured from the finished ground level or from the base plate, and whether the top rail will remain level or follow the slope.

Also ask how the design accounts for any required clearance at the bottom of the panel.

Checking Post Spacing and Fixing Points

Post spacing determines the structural strength and the final appearance of a custom fence. Confirm the planned distance between posts, the type of fixing (embedded, base plate, or wall mounting), and whether the existing structure can carry the load.

A written drawing with marked dimensions makes it much easier to check these details before production begins.

Safety and Compliance Points to Confirm

For railings and fences near drops or stairs, the Israeli railing standard SI 1142 is relevant. This guide does not list exact values, because the correct figures depend on the specific location and use. Ask the manufacturer to confirm how the design addresses the applicable requirements, and have your engineer check any critical dimension.

Preparing Your Measurements and Photos

Good preparation speeds up the process. Take photos of the full area from several angles, note any obstacles such as pipes or meters, and measure the width and height at more than one point. Mark where gates or openings are planned.

An on-site measurement by the manufacturer is still recommended, because small differences often appear only on the wall itself.

Frequently asked questions

Can every fence panel be made to a custom size?

Most iron and aluminum fence designs can be adapted to custom dimensions, although some profiles and patterns work better at certain widths. Ask the manufacturer which options suit your design.

Should I measure the panel width myself?

You can take preliminary measurements, but an on-site check by the manufacturer is the safest way to confirm the final sizes. Small variations in walls and ground often matter.

Do custom panels take longer to produce?

Custom work usually requires drawing and approval steps before production, so it is wise to ask about the timeline at the start. Specific timing should be confirmed directly with the factory.

What information should I send with my first inquiry?

Send clear photos of the area, rough dimensions, the purpose of the fence, and any gate or slope details. This allows a faster and more accurate response.

Common mistakes to avoid

Ordering panels from rough estimates without checking the actual opening on site is the most common error. Forgetting to confirm how measurements are taken, such as center to center or inside to inside, can also cause fit problems.

Our recommendation

Ask for a written drawing with all dimensions marked before approving production, and request an on-site measurement for any opening that is not perfectly regular. This single step prevents most fitting issues.

Summary

Custom fence panel sizes give you a precise fit for irregular openings and slopes, as long as the measurements and fixing details are confirmed in writing before production.

השאירו פרטים ונחזור אליכם