Glass Partition Systems with Integrated Power Outlets in the Frame

t428-45

A glass partition with integrated power outlets carries cabling inside its aluminum or steel frame, so workstations get power without exposed cords or surface boxes. It works best when the electrical layout, cable routes and frame profile are decided together before the glass is cut.

What an integrated power outlet in a glass partition means

Instead of running power along the floor or mounting boxes on the wall, the outlet sits inside the frame of the partition itself. The frame becomes a raceway: cables pass through a dedicated channel and the socket is fitted into a profile section that stays clean and aligned with the glass line.

This suits open offices and meeting rooms where desks change position often, because the partition already carries the supply and the layout stays tidy.

Planning the electrical layout early

The electrician, the office planner and the metalwork shop should agree on outlet positions before production starts. Frame channels, junction points and the mounting height of each socket all have to match the drawing.

Count the outlets per workstation and their exact positions
Mark where the power enters the partition and where it exits
Confirm cable types and diameters with the electrician
Note any data or network cables that share the same channel

Frame design and cable routing

The profile must leave enough internal space for the cable bundle and allow access for pulling wire. We make this decision on the drawing, not on site, so there are no surprises during installation.

Access points, such as removable caps or inspection openings, should be placed where maintenance will be easiest. Safe separation between power and data lines is part of the design, and the electrician confirms the final requirements for your building.

Materials and finishing

Aluminum profiles are common for interior glass partitions because they are light and easy to shape around channels. Steel frames suit heavier installations or a stronger look. Both can be finished in powder coating to match the office palette.

Where the partition sits in a damp area or near outdoor glazing, hot-dip galvanizing is used for steel parts. Glass type and thickness are chosen for the partition's span and safety requirements.

How the work process runs with us

The process starts with an inquiry and photos of the space. We then measure on site, prepare a drawing and a written specification, and wait for your approval before production begins.

Inquiry with photos and the outlet plan
On-site measurement
Drawing and written specification
Client approval
Production at our Tel Aviv factory, then finishing
Installation with the electrician coordinating the connection

Safety and building compliance

Glass partitions and their railings and fixings are subject to Israeli standards, including the railing standard SI 1142 for general requirements. Exact dimensional and load values depend on the specific installation and are checked with the engineer for each project.

Electrical connection must be carried out by a licensed electrician who signs off the wiring, so the outlets and cable routing meet the rules that apply to your site.

Frequently asked questions

Can outlets be added to an existing glass partition?

In most cases it is better to plan outlets into the frame at the design stage. Retrofitting depends on the frame profile and the space inside it, so it is checked on site before any decision.

Do power and data cables share the same frame channel?

They can share a frame, but the design should separate them where needed. The electrician confirms the required separation for your installation.

How do I access the cables later for maintenance?

We plan access points such as removable caps or inspection openings during the drawing stage. Their position is set so maintenance stays practical.

Who connects the power to the outlets?

A licensed electrician carries out the connection and signs off the wiring. We coordinate the frame and cable route with them during installation.

Common mistakes to avoid

Ordering the glass before the outlet positions are fixed is the most common error, since the frame channel must match the electrical plan. Leaving the electrician out of the drawing stage often leads to cables that do not fit the profile.

Our recommendation

Send us your outlet plan with photos before choosing the frame profile, and ask your electrician to review the drawing. Settling these points first avoids costly changes after production.

Summary

Glass partitions with integrated power outlets keep cables hidden and layouts flexible when planned together with the electrician. Decide outlet positions and cable routes before production to get a clean result.

השאירו פרטים ונחזור אליכם