Ready to Order Your Gate? Final Checklist Before Confirming

t273-47

Before confirming a gate order, check the exact opening width and height, the swing or sliding direction, the choice of automation, and the finish that suits your climate. Review the drawing and written specification carefully, because most changes are cheap before production and costly after it.

Confirm the Measurements on Site

Measurements should be taken on site, not from memory or an old plan. Measure the opening at the top, middle and bottom, since walls are rarely perfectly straight. Note the ground slope, the height of the curb or pavement, and any obstacles such as trees, meters or a driveway edge that will affect how the gate moves.

Clear width and height of the opening
Post or wall details where the gate will be fixed
Space needed for the gate to open fully

Decide the Opening Direction and Style

Decide whether the gate will swing inward or outward, or slide along the fence line. Consider which side has more free space, where cars will park, and whether pedestrians need to pass safely. A sliding gate needs enough clear length beside the opening, while a swing gate needs room to clear the driveway and any slope.

Review the design with the drawing in hand so you can see the infill pattern, height and gap spacing before you agree.

Choose Automation and Accessories

If you plan to add an electric motor, decide this now, because it affects the posts, hinges, wiring routes and the foundation. Think about remote controls, keypads, intercoms, safety sensors and emergency release. Confirm where the power source is and whether cables need to be run in advance.

Select the Finish for Your Climate

The finish protects the gate from weather and wear, so choose it with your surroundings in mind. Sea air and sun exposure can be hard on bare metal, so ask about the protection method used before production. Hot-dip galvanizing followed by powder coating is a common choice for long-term outdoor use. Pick a colour that matches your fence, facade and paving, and ask to see sample colours in daylight.

Check Safety and Local Requirements

Gates that are used by children, pets or vehicles should be designed with safety in mind. Check gap sizes, finger-trap risks, and the height of any railing or infill near the gate. For railing elements, the Israeli standard SI 1142 is a useful reference, but exact values should always be confirmed with your engineer or the installer before you approve the drawing.

Review the Written Specification and Timeline

Before confirming, read the written specification line by line. Make sure it lists the dimensions, materials, opening type, finish, hardware and any automation. Ask when installation will take place and what preparation you need to do, such as clearing the area or preparing the power supply. Keep a copy of the approved drawing for your records.

Frequently asked questions

Do I need to measure the gate opening myself before ordering?

Yes, it is best to have the opening measured on site, and we can do this for you. Measuring at the top, middle and bottom helps catch uneven walls or ground slopes.

Can I change the design after I approve the drawing?

Changes are usually simplest before production starts, so raise any concerns during the drawing review. Ask for an updated drawing and written specification after any change.

Should I decide on an electric motor now or later?

Decide now if possible, because the posts, hinges and wiring need to be planned together. Adding automation later can require extra work on the foundation and cabling.

What finish is best for an outdoor gate?

A galvanized base with powder coating is a common choice for outdoor durability. Your final choice depends on sun, sea air and the look you want to match.

Common mistakes to avoid

The most common mistakes are ordering based on rough measurements and forgetting to plan for the opening swing or slope. Skipping the written specification review can also lead to surprises at installation.

Our recommendation

Walk the site with the drawing in hand and mark the opening, clearance and power point before you confirm. Ask us to review the specification together so that every detail is agreed in writing.

Summary

A careful final check of measurements, opening direction, automation, finish and specification helps your gate fit well and last. Confirm everything in writing before production begins.

השאירו פרטים ונחזור אליכם