Request a Quote for Custom Stainless Steel Building Works

t466-45

To request a quote for stainless steel fabrication, send Techno Kol Uzi your project photos and basic dimensions, then book an on-site measurement. You receive a drawing and written specification to approve before production starts in our Tel Aviv factory.

What to Include in Your Quote Request

A clear request saves time on both sides. Start with photos of the area where the stainless steel work will go, and note the building type, floor level and the purpose of the element, such as a railing, handrail, canopy, partition or structural support.

Approximate dimensions of the opening or run
Preferred finish, such as brushed or polished
Whether the work is indoor, outdoor or near the sea
Your timeline and site access details

If you have architect drawings or a contractor's specification, attach them. They help us match your requirements exactly.

The On-Site Measurement Visit

Once we review your request, we arrange a visit to measure the site. Accurate measurement is the foundation of custom work, because stainless steel is fabricated to the millimeter and cannot easily be trimmed on site.

During the visit we check wall conditions, anchoring points, levels and any obstacles. We also discuss how the element will be fixed, so the design suits the structure it attaches to.

Drawing and Written Specification

After measuring, we prepare a drawing and a written specification covering materials, grade of stainless steel, dimensions, welding and finishing method, and installation approach. Nothing moves to production until you have reviewed and approved these documents.

What the specification covers

Steel grade and thickness suited to the environment
Joint and welding details
Surface finish and protection
Fixing method and installation sequence

Production in Our Tel Aviv Factory

Our factory at 37 Rival Street, Tel Aviv has operated since 1945, and today it is run by the third generation of the family. Every stainless steel element is cut, formed, welded and finished in-house, which gives us direct control over quality and schedule.

We work with stainless steel for structures, railings, partitions and architectural details, adapting each piece to the specific building and its requirements.

Installation and Coordination

Installation is coordinated with your contractor or site supervisor. We confirm access, delivery route and the order of work so the stainless steel elements arrive when the site is ready to receive them.

For railings and load-bearing elements, fixing details are checked against the relevant Israeli standard, and exact values are confirmed with the project engineer before installation.

Tips for Contractors and Property Owners

Contractors benefit from sending complete drawings early, so that anchor points can be built into the concrete or masonry work. Property owners and building committees should confirm decision-makers and approval steps before the measurement visit.

Keep all approved drawings and the specification in one place. They serve as your reference for installation and for any future maintenance.

Frequently asked questions

How do I start a quote request for stainless steel fabrication?

Send us photos of the area, rough dimensions and a short description of what you need. We will reply to arrange an on-site measurement.

Do you measure on site before quoting?

Yes. Accurate on-site measurement is required before we prepare the drawing and written specification for your approval.

Can you work from an architect's drawings?

Yes, we can work from architect or engineer drawings and will check them against the actual site measurements before production.

Is anything produced before I approve the specification?

No. Production starts only after you have reviewed and approved the drawing and written specification.

Common mistakes to avoid

Ordering stainless steel based on rough estimates without a site measurement often leads to misfit elements. Also avoid skipping the approved specification, since it protects both the client and the installer.

Our recommendation

Send your request with clear photos and a list of the anchoring surfaces, and make sure the structure is ready before the measurement visit. This lets the drawing and specification be finalized quickly and installation run smoothly.

Summary

Request a quote by sending photos and dimensions, then approve a measured drawing and specification before Techno Kol Uzi fabricates your stainless steel works in Tel Aviv.

השאירו פרטים ונחזור אליכם