Safety Glass Standards for Israeli Homes: What to Check

t445-22

Glass used in windows, doors and balconies in Israeli homes should be safety glass, such as tempered or laminated glass, where the building codes and the nature of the opening require it. The exact requirements depend on the location, height and use of each glass panel, so confirm them with your engineer and supplier before ordering.

Why glass safety matters at home

Glass is strong in daily use, but when it breaks it can cause serious injury. Safety glass is designed to break in a controlled way or to stay together when damaged. This matters most near doors, low windows, balconies and any place where people could fall against the glass.

When you choose Belgian steel-look profile windows and doors, the frame gets most of the attention, but the glass deserves equal care. The glass type affects safety, sound insulation, heat control and the overall look of the opening.

Common types of safety glass

Two types are most often used in residential openings:

Tempered glass, heat-treated to resist impact and to break into small, blunt pieces.
Laminated glass, made of two layers bonded by an interlayer, which stays in place when cracked.

Each type suits different situations. Your supplier can explain which one fits a specific opening.

Where safety glass is usually required

Safety glass is commonly expected in doors, glass panels next to doors, low openings near floor level, shower-type enclosures and glass balustrades. Balcony glass also needs careful review because of the height and the people who may lean against it.

Rules and interpretations can change, so do not rely on general habits alone. Ask for the specific locations in your home that need safety glass to be marked on the drawing.

The role of the Israeli railing standard

When glass forms part of a railing or balcony guard, the Israeli railing standard SI 1142 is relevant. It sets out general requirements for protection and strength. The exact values and load requirements are checked with the engineer for your project, and we do not recommend relying on rough measurements.

If your opening combines a glass panel with a steel-look frame, the engineer should review both together so the whole assembly performs as intended.

How the process works with us

Our process starts with an inquiry where you send photos of the openings. We then measure on site and prepare a drawing and written specification. The specification should state the glass type, thickness and locations of safety glass.

After you approve the specification, we produce the frames in our factory at 37 Rival Street, Tel Aviv, and finish them with hot-dip galvanizing or powder coating before installation. This gives you a clear record of what was ordered and why.

Questions to ask before you order

Before approving a quote, ask your supplier:

Which openings use tempered or laminated glass, and why?
Does the glass meet the requirements for railings or balconies at my height?
Will the engineer review the glass and frame together?
Is the glass type written in the final specification?

Clear answers now prevent changes after installation.

Frequently asked questions

Is all glass in a home required to be safety glass?

Not always. Safety glass is typically required in specific locations such as doors, low panels and balconies, so the requirement depends on where each glass panel sits.

What is the difference between tempered and laminated glass?

Tempered glass is heat-treated and breaks into small, blunt pieces. Laminated glass has an interlayer that holds the broken pieces together, which makes it useful for overhead or high-risk areas.

Does SI 1142 apply to my balcony glass?

The Israeli railing standard SI 1142 is relevant when glass serves as a railing or guard. Your engineer should confirm the exact requirements for your project.

How can I confirm my glass meets the rules?

Ask for a written specification that lists the glass type, thickness and locations, and have the engineer review it before production begins.

Common mistakes to avoid

Choosing glass based only on appearance or cost, and skipping the step where the location of each panel is checked against safety requirements. Forgetting to write the glass type into the final approved specification.

Our recommendation

Mark every glass panel on the drawing by location and confirm the required glass type with your engineer before production. Keep the signed specification with your project papers.

Summary

Safety glass for Israeli homes depends on each panel's location, height and use, and it should be confirmed in writing before production.

השאירו פרטים ונחזור אליכם