Can You Fabricate a Steel Frame for a Sliding Gate?

t478-28

Yes, Techno Kol Uzi fabricates custom steel frames for sliding gates, sized to your exact opening and built to carry the weight of the gate leaf and the forces of its movement. The frame is cut, welded and finished in our factory at 37 Rival Street, Tel Aviv, and then installed on site.

What a sliding gate steel frame does

The frame is the rigid structure that holds the gate leaf and guides its movement. It carries the weight of the leaf, resists wind pressure and keeps the gate square as it slides open and closed. A well-built frame keeps the gate running smoothly for years, while a weak one leads to sagging, rubbing and misalignment.

Because the frame supports the whole gate, its dimensions and steel profile matter as much as the leaf design itself.

How we measure and design the frame

Every frame starts with an on-site measurement. We check the width and height of the opening, the wall or pillar construction, the ground level and the position of the rail. Photos help us understand the surroundings before we visit.

From these measurements we prepare a drawing and a written specification showing the profile sizes, weld points and fixing method. You review and approve it before any steel is cut.

Materials and profiles we use

Frames are typically made from hollow structural steel sections, chosen according to the gate length and weight. Heavier gates need thicker profiles and additional bracing. We select the material with you, based on the drawing and the intended use.

Profile size matched to gate weight and span
Reinforcement at the leading and trailing edges
Guide and roller mounting points planned in advance

Fabrication and finishing in our factory

The steel is cut, assembled and welded in our Tel Aviv workshop. Welds are checked for alignment and strength before the frame moves to finishing. We protect the steel with hot-dip galvanizing where durability against weather is needed, followed by powder coating in the colour you choose.

Finishing is done before installation so the frame arrives on site ready to be fixed.

Installation and alignment

On site, the frame is set level and plumb, fixed to the pillars or foundation, and checked for square. The rail and rollers are aligned to the frame so the leaf runs straight. Careful alignment at this stage prevents most problems that owners later attribute to the gate itself.

Safety features such as stops and guide rollers are fitted and tested before handover.

Standards and what to confirm with your engineer

Gate and railing work in Israel should follow the relevant standards, including the Israeli railing standard SI 1142 where it applies. Exact load values, fixing requirements and clearances depend on your site and should be confirmed with the structural engineer on your project.

We are happy to work from the engineer's requirements and build the frame to match them.

Frequently asked questions

Can you make a frame for an existing gate?

Yes, we can design a new frame to fit an existing gate leaf, provided we measure it and check its weight and condition first. In some cases the leaf needs repair or replacement as well.

Do you install the frame as well as make it?

Yes, we fabricate the frame in our factory and install it on site, with alignment and safety checks at handover.

How long does a steel sliding gate frame last?

Lifespan depends on the steel protection, the weather exposure and maintenance. Hot-dip galvanizing and powder coating help the frame resist corrosion over time.

Do you need the gate drawings before you start?

No, we can start from a site measurement and photos. Existing drawings are helpful if they are available but are not required.

Common mistakes to avoid

Owners often choose a frame by appearance alone and overlook weight, span and ground conditions. Skipping alignment at installation is another common error that causes sticking and early wear.

Our recommendation

Measure the opening carefully, confirm the foundation and rail position before fabrication, and have the structural engineer review the load requirements. Choose galvanizing for exposed sites.

Summary

We fabricate custom steel frames for sliding gates at our Tel Aviv factory, from measurement and drawing through finishing and installation. The frame is designed around your opening, weight and site conditions.

השאירו פרטים ונחזור אליכם