Custom Steel-Look Window Quote with Exact Dimensions

t442-35

To get an accurate custom steel-look window quote, you need exact width, height, frame depth and opening type, measured on site with photos. Techno Kol Uzi produces Belgian steel-look profile windows and doors to measure, so a precise written specification is confirmed before production begins.

Why exact dimensions matter for a steel-look window

A steel-look window is made to fit one specific opening. Even a few millimeters of error can affect how the frame sits, how the sash closes and how the glass is seated. That is why a quote based on rough numbers is only an estimate, while a quote based on measured dimensions can be taken into production.

Exact dimensions also protect you from surprises at installation day, when a window that was ordered by guesswork does not fit the wall as built.

What to measure before you ask for a quote

Measure each opening at three points for width and height, because walls are rarely perfectly straight. Record the results in millimeters and write down which measurement is the outer edge of the opening.

Width at top, middle and bottom
Height at left, center and right
Depth of the wall or reveal
Sill height from the floor

Take a clear photo of each opening from inside and outside the room.

Choosing the opening type and layout

Decide how each window opens before requesting the quote. Common choices include fixed panels, side-hung casements, tilt-and-turn and sliding units. The opening direction affects handle position, screen placement and the clearance needed next to furniture or railings.

Note the number of panels and where any vertical or horizontal divider should sit, so the drawing reflects what you actually want to see from the room.

What to send us with your inquiry

Send the measurements, photos and a short description of each window in one message. If the openings are in an apartment or building with a committee, mention that too, since approvals may be needed for facade changes.

Tell us the finish you prefer for the steel-look profile and whether the window is for a new build or a replacement, because these affect how the frame is fixed.

How the quote and approval process works

After receiving your inquiry, we review the photos and dimensions and may arrange an on-site measurement if the details need checking. We then prepare a drawing and a written specification showing sizes, opening type, profile and finish.

Nothing goes into production until you have reviewed and approved this specification, so you can check every dimension before the work starts.

From approved drawing to installation

Once approved, the window is manufactured at our factory on Rival Street in Tel Aviv and finished with the chosen treatment. Installation follows, with the frame checked for level and plumb against the opening.

Keeping the same measurements through every step is what makes the final window fit the wall it was designed for.

Frequently asked questions

Do I need a professional to measure before I request a quote?

Not always. Careful measurements with a steel tape and a photo often work well, but if the wall is uneven or the opening is unusual, we can arrange an on-site measurement.

Can I send an inquiry without exact dimensions?

Yes, you can start with approximate sizes and photos. However, a final quote and drawing require exact measured dimensions before production.

Is the steel-look window the same as a steel window?

It is a profile window designed to look like steel, offering the slim lines of steel with the construction of a modern window. Please ask us for details on the specific profile we would use for your project.

Do you handle windows for building committee approvals?

We can provide drawings and specifications that help with the approval process. Your committee or engineer should confirm the requirements that apply to your building.

Common mistakes to avoid

The most common mistake is measuring only once and in one place, which misses wall irregularities. Another is forgetting to note which way each window opens, which changes the drawing.

Our recommendation

Measure every opening at three points, write each figure in millimeters, and send photos with the inquiry. Confirm the final dimensions in the written specification before approving production.

Summary

Exact measurements, clear opening details and a reviewed written specification are what turn a rough idea into an accurate custom steel-look window quote.

השאירו פרטים ונחזור אליכם