Steel-Look Door Site Survey: Measure Before You Order

What a Site Survey Covers

The survey is a practical check of the exact spot where the door will go. We measure width and height at several points, since older walls are rarely perfectly square. We also look at the floor level, the threshold, the wall thickness and any obstacles such as tiles, pipes or electrical boxes.

Each measurement is written down and photographed so nothing depends on memory. This gives you a reliable starting point for the drawing.

Why Measuring Before Ordering Matters

Steel-look profile doors are made to measure, so a small error on paper can become a big problem on site. A door that is a few millimeters too wide may not close, and one that is too short leaves a gap that lets in air and water.

Measuring first protects you from reordering and from delays while the door waits to be fixed on site.

What Happens During the Visit

• Review of your photos, plans or previous specifications
• Measurement of the opening at top, middle and bottom
• Check of wall, floor and threshold conditions
• Discussion of opening direction, glazing and hardware
• Notes and photos for the written specification

The visit usually focuses on one opening at a time, so the result is clear and easy to check.

From Survey to Drawing and Approval

After the survey, we prepare a drawing and a written specification based on the measured dimensions. You receive it for review before anything goes into production. Please check the sizes, the opening direction and the finish against what you discussed on site.

Once you approve the drawing in writing, the order moves to the factory. Changes after approval may affect the schedule, so it is worth reviewing everything carefully at this stage.

Preparing for the Survey

Some preparation makes the visit faster. Clear the area around the opening, let us know if the wall is still being finished, and share any existing drawings or photos you have. If an old door is being replaced, keeping the old frame details helps.

If you are working with an architect, interior designer or contractor, invite them to the visit so decisions are made once.

Structural and Safety Checks

Where a door is part of a wall with load, or where it sits next to a balcony or stairs, we discuss the fixing method and any safety requirements. For railings and similar elements, Israeli standard SI 1142 applies in general, and exact values are confirmed with your engineer rather than assumed from memory.

Raising these points during the survey avoids changes once production has started.

Frequently asked questions

How long does a steel-look door site survey take?

Most surveys for a single door take a short visit on site, depending on the opening and how much detail needs checking. We confirm the timing when you book.

Do I need to be present during the survey?

It is helpful if you or your representative can attend, so questions about opening direction, glazing and finish can be settled on the spot. If you cannot attend, send clear photos and any notes in advance.

Can the survey be done before the wall is finished?

It is better to measure once the opening is close to final, because plaster, tiles and floor levels change the dimensions. If the wall is still in progress, we can take preliminary measurements and check again later.

Is there an obligation to order after the survey?

No. The survey gives you accurate measurements and a specification to review, and you decide whether to proceed.

Common mistakes to avoid

Ordering from rough measurements taken before the wall is finished is the most common error. Changing the opening direction or glazing after approval also causes avoidable delays.

Our recommendation

Measure once the opening is near its final state, and review the drawing line by line before approving it in writing. This single step prevents most fitting problems.

Summary

A steel-look door site survey gives exact measurements and a reviewed drawing, so your Belgian steel-look door is made to fit the opening the first time.

Related guides

• Book a Steel-Look Window Installation Appointment Within Your Schedule
• Order a Custom Belgian Steel-Look Window Quote with Exact Dimensions
• Choose Steel-Look Window Colors and Order a Physical Sample Kit
• Steel-Look Window Opening Sizes That Suit Small Kitchen Walls
• Steel-Look Sliding Door Replacement Request for Existing Rail Tracks
• Steel-Look Pivot Doors: Floor Spring Load and Door Weight Limits
• All models in this category