Do We Offer Custom Steel Frames for Signage and Billboards?

t478-37

Yes, Techno Kol Uzi Ltd. manufactures custom steel frames and structures for signage and billboards. Each frame is designed and fabricated to the exact dimensions, load and mounting conditions of your site. We work from your photos and an on-site measurement, then supply a drawing for approval before production.

What we can build for signage and billboards

Our workshop at 37 Rival Street in Tel Aviv has been producing metalwork since 1945, and steel frames for signs are part of that work. We fabricate free-standing frames, wall-mounted brackets, rectangular and irregular profiles, and supporting structures that hold a sign panel or a billboard face. Frames can be built from steel sections sized to the load of your panel and the height where it will be installed.

Rectangular and custom-shaped sign frames
Wall and roof mounting brackets
Free-standing posts and cross-members
Supporting structures for billboard faces

How the design is prepared

A good frame starts with accurate information. Send us photos of the location, the sign or panel size, and where the frame will sit. We then visit the site to measure, check the wall or ground conditions, and confirm access for installation. Based on this we prepare a drawing and a written specification showing sections, dimensions and connection details.

Nothing goes into production until you have approved the drawing. This step catches sizing mistakes early, when they are still easy and inexpensive to correct.

Materials and finishing

Frames are normally made from structural steel, which gives the rigidity that a large sign needs in wind. Where the frame will be exposed to weather for years, we finish it by hot-dip galvanizing and powder coating, which protects the steel and keeps the colour consistent. For a cleaner look on indoor or sheltered signs we can use stainless steel or other finishes discussed during the inquiry.

The right finish depends on the environment, so we recommend deciding this together at the start rather than after fabrication.

Loads, wind and safety

A sign or billboard catches wind, and that force travels into the frame and its fixings. Frame size, section choice and anchoring all need to suit the wind exposure of the location. We design with these loads in mind, but exact structural values and any required engineering calculations are confirmed with the project engineer for your specific installation. Please share the intended height and location so this can be checked properly.

Installation and coordination

We can deliver the frame and coordinate installation so the fixings line up with the wall, ground or structure it is attached to. Working with your sign company or contractor from the beginning helps avoid surprises on site. Clear drawings make it easy for installers to follow the connection points and dimensions.

Working with advertisers and sign companies

We regularly work with advertisers, sign companies, contractors and architects who need a frame built to a specific drawing. Tell us the panel size, the number of units, the finish you need and the installation date, and we will confirm what is practical. Repeat units can be produced consistently from the same approved drawing.

Frequently asked questions

Can you build a frame to a size and shape I provide?

Yes. Send your drawing or sign dimensions and we will check them against the site measurement before production. Any adjustments are shown to you in the drawing for approval.

Do I need to send a drawing to start?

No. Photos and the approximate size are enough to begin. We take the exact measurements on site and prepare the drawing ourselves.

How do you protect the frame from weather?

Outdoor frames are typically hot-dip galvanized and powder coated. We recommend the finish based on the location and how long the frame needs to last.

Do you handle installation?

We can coordinate installation and align fixings with the wall or ground structure. Confirm the details with us when you send your inquiry.

Common mistakes to avoid

Ordering a frame before confirming the wind exposure, mounting surface and final panel weight. These details change the section size and fixings, so share them early.

Our recommendation

Send the panel dimensions, weight, mounting height and a few site photos in your first message. With these, we can give you a realistic drawing faster and avoid redesigning the frame later.

Summary

Techno Kol Uzi builds custom steel frames and structures for signage and billboards, designed from a site visit and approved in drawing before fabrication.

השאירו פרטים ונחזור אליכם