Request a Quote for Child-Safe Barrier Sensor Retrofits

t459-47

A barrier sensor retrofit adds safety detection, such as loop or photocell sensors, to an existing parking barrier so it stops or reverses when a child, pet or object is in its path. To get an accurate quote, send photos of the barrier and its surroundings, the make and model if known, and a short description of the traffic and residents who use it.

Why retrofit safety sensors on an existing barrier

Many residential parking barriers were installed before modern safety detection became common. A barrier that closes without sensing what is beneath it can pose a real risk to children playing near the entrance, as well as to bicycles, pets and small vehicles.

A retrofit lets you improve safety without replacing the whole barrier. Building committees often choose this route because it keeps the existing mechanism in service while adding protection where it matters most.

Types of sensors we typically assess

The right sensor depends on how the barrier moves and how the area is used. Common options include:

Photocell beams placed across the opening, which detect anything crossing the path
Safety edge sensors fitted to the barrier arm, which stop or reverse on contact
Loop detectors embedded in the ground, which mainly detect vehicles

We discuss the options with you on site before recommending one.

What to send when you request a quote

A clear inquiry helps us prepare an accurate proposal faster. Please include photos of the barrier, the posts and the area around them, plus the make and model if the name plate is visible. Note whether the barrier is used by cars only, or also by pedestrians and bicycles.

Tell us if children regularly play nearby, and whether the barrier is operated by a remote, a keypad or a card reader. These details shape the sensor arrangement.

Our process from inquiry to installation

After your inquiry we arrange an on-site measurement and review the existing wiring and controller. We then prepare a drawing and a written specification for your approval, so every part of the work is agreed in advance.

Once approved, components are prepared in our factory at 37 Rival Street, Tel Aviv, and finished to suit the outdoor conditions. The sensors are then installed and tested with you on site.

Standards and safety checks

Safety requirements for automatic barriers and the sensors that protect them are set out in Israeli standards, and the required detection arrangement depends on the specific barrier and site. We do not rely on general figures here; exact dimensions, heights and clearances are checked with the responsible engineer for your building.

Once installed, the system should be tested to confirm that the barrier reverses or stops correctly when an obstacle is detected.

Preparing your building for the work

Before the installation day, let residents know that the barrier will be out of service for a short period. Clear the area around the posts so our team can work safely and access the wiring.

If the building committee needs to approve the work, we can provide the written specification and drawing to support that decision.

Frequently asked questions

Can a sensor be added to any parking barrier?

Most automatic barriers can be retrofitted, but the suitable sensor depends on the mechanism and controller. We confirm compatibility during the on-site measurement.

Do I need to replace the whole barrier?

Usually not. A retrofit adds sensors to the existing barrier, although in some cases a component may need replacing to work safely with the new detection.

What information should I include in my quote request?

Send photos of the barrier and its surroundings, the make and model if visible, and details about who uses the area, including pedestrians, children and bicycles.

How do I know the sensors meet the required standard?

We review the arrangement against the applicable Israeli standard and confirm exact requirements with the responsible engineer before installation.

Common mistakes to avoid

Requesting a quote without photos or without mentioning pedestrian and child traffic often leads to an incomplete proposal. Assuming the sensor type is the same for every barrier can also result in poor coverage.

Our recommendation

Walk the area at the times children are most likely to be present, and note every point where someone could be in the barrier's path. Share these observations with us so the sensor layout protects those exact spots.

Summary

A child-safe sensor retrofit improves an existing parking barrier without full replacement. Send clear photos and usage details to get an accurate, specification-based quote.

השאירו פרטים ונחזור אליכם