Selecting a Door Model Based on Installation Requirements

t446-44

Choose a door model by first confirming the opening size, wall construction, swing direction, traffic and security needs, and the exposure of the location. Then match the profile system and finish to those requirements, and have the final specification checked on site before production.

Start with the opening, not the catalogue

Door model selection begins with the opening itself. A door that looks right in a photo can fail on site if the frame depth, wall thickness or threshold height does not suit it. Before comparing designs, note the clear width and height, the sill condition and whether the opening is in a new build or a renovation.

Also record the wall material and how the frame will be fixed. Masonry, concrete and existing frames each need a different fixing approach, and this affects which door profile is practical.

Check the swing, the side and the threshold

Decide the swing direction and which side the handle should sit on, based on the room behind the door and the path people take through it. Confirm whether the door opens inward or outward, since this changes the hinge side and the weather seal.

Note floor finish height, including tiles or screed still to be laid
Check the space needed for the leaf to open without hitting furniture
Decide whether a low threshold is needed for wheelchair or stroller access

Match the profile system to use and exposure

Belgian steel-look profile doors come in different profile sizes and glazing options. A heavier profile suits high-traffic or exposed entrances, while a lighter arrangement may be enough for an interior or sheltered opening. Consider how much sun, wind and rain reach the door, as this shapes both the sealing and the finish choice.

Glazing, ventilation grilles and security hardware all change the door's weight and fixing needs, so settle these early rather than adding them after the drawing is approved.

From inquiry to drawing and written specification

A typical project starts with an inquiry and photos of the opening. We then measure on site and prepare a drawing with a written specification covering dimensions, profile, glazing, opening direction, hardware and finish. You review and approve this before anything goes into production, so the details are fixed in writing.

Production and finishing in the factory

Once approved, the door is manufactured in our Tel Aviv factory to the measured dimensions. Steel components can be finished by hot-dip galvanizing and powder coating, which protects the surface and provides the colour and texture you chose. Finishing is planned together with the profile so the result matches the drawing.

Installation and final checks

On installation day, the frame is fixed plumb and level, the leaf is hung and adjusted, and the seals and hardware are checked for smooth operation. Where a balustrade or railing meets the door, the Israeli railing standard SI 1142 applies in general terms, and exact values are confirmed with the engineer. Ask for a short walk-through of how to operate and maintain the door before we leave.

Frequently asked questions

What measurements do I need before choosing a door model?

You need the clear width and height of the opening, the wall thickness, the floor finish height and the swing direction you prefer. A site measurement by our team confirms these before any drawing is made.

Can a steel-look profile door fit an existing frame?

It can, but the existing frame must be checked for size, condition and fixing method. In some cases the frame needs adjustment or replacement to take the new door safely.

Which factors matter most for an exterior door?

Exposure to sun, wind and rain, the level of security needed and how often the door is used all matter most. These points guide the profile, sealing and finish you should choose.

Do I approve the specification before production starts?

Yes. You receive a drawing and written specification, and production begins only after you approve it in writing.

Common mistakes to avoid

The most common mistake is ordering from a photo without measuring the opening and confirming the swing direction. Changes made after production are costly and often delay installation.

Our recommendation

Measure the opening on site, decide the swing and threshold height before choosing a profile, and approve a written drawing before production. This sequence prevents most fitting problems.

Summary

Good door model selection starts with the opening, then the swing, use and exposure, followed by a checked drawing and specification. Approving these details before production leads to a smooth installation.

השאירו פרטים ונחזור אליכם