What to Prepare Before Ordering an Electric Parking Gate

t282-37

Before ordering an electric sliding or swing parking gate, prepare the exact opening width and height, photos of the entrance and surroundings, and details about the driveway slope, power source and how the gate will be operated. Having these ready lets the factory draw an accurate specification and avoid delays on site.

Measure the Opening Accurately

The most important figure is the clear width of the opening, measured between the posts or walls at the widest and narrowest points. Measure the height from the ground to the top of the opening, and note any slope, since a sloped driveway changes how the gate must be built and where it can travel.

Clear width at top, middle and bottom
Clear height at both sides
Depth of space behind a sliding gate for the track

Write every figure down with the unit and sketch the layout, even roughly.

Decide Between Sliding and Swing

A sliding gate runs along a track and suits a driveway where there is free space alongside the opening. A swing gate opens outward or inward on hinges and needs clear space in the swing arc. Check whether a car, a tree, a wall or a parked vehicle would block the movement.

Tell the factory which type you prefer and whether there are any constraints on the space, so the design can be matched to the site.

Prepare Photos and Site Details

Clear photos help the team understand the entrance before the visit. Take a wide photo of the whole entrance, a close photo of each post or wall, and one from inside the property looking out. Include the surrounding fence or gate pillars if they are part of the work.

Also note the material of the existing posts, whether they are brick, concrete or steel, because this affects how the gate is fixed.

Plan the Power and Automation

Electric gates need a power point near the gate and, usually, a cable route to the motor. Note where the nearest electrical supply is and whether a dedicated circuit exists. If you already have a remote, intercom or access system in mind, mention it at the start.

Decide whether you want a remote control, keypad, phone opening or an intercom, since each option affects the wiring and the controller choice.

Describe Finish, Style and Use

Tell us how the gate will look and how it will be used. Share a photo of the house or fence it must match, and mention the colour or finish you prefer. Describe how often the gate will be used and by how many vehicles, because heavy daily use may call for a more robust motor and hinges.

Finishing options such as hot-dip galvanizing or powder coating can be discussed once the design is settled.

Confirm Measurements On Site

Even with careful measuring, a site visit is important. The team checks the opening, the ground, the slope and the installation points before drawing the final specification. Make sure someone who knows the property is available at the visit and that the area is accessible.

Once the drawing and written specification are approved, production begins in the factory and installation follows.

Frequently asked questions

Do I need to know the exact gate type before I ask for a quote?

No. Describe the opening and how you plan to use it, and the team can recommend whether a sliding or swing gate suits the site better.

Why does the driveway slope matter?

A slope affects the gate's track or hinge layout and the ground clearance. It also influences how the gate is anchored and how it moves smoothly.

Can I send photos instead of coming to measure myself?

Photos help a lot, but they are not a substitute for on-site measurement. The team will confirm the exact dimensions before drawing the final specification.

What if I do not know where the power point is?

Mention that when you enquire. The installer can check the nearest supply during the site visit and advise on the cable route.

Common mistakes to avoid

The most common error is measuring only the width and forgetting the height, slope and swing or track space. Ordering before confirming these details often leads to a gate that does not fit or cannot move freely.

Our recommendation

Measure at three points across the width and at both sides for height, then take a wide photo and note the power point location before you contact the factory.

Summary

Prepare accurate opening measurements, site photos, the gate type you prefer, power details and your finish preferences before ordering an electric parking gate.

השאירו פרטים ונחזור אליכם