Kick Plate Aluminum Door Protection for High-Traffic Entrances

t419-36

A kick plate aluminum door is a protective metal panel fitted to the lower part of a door to absorb the wear from feet, trolleys and cleaning equipment. For businesses and buildings with heavy traffic, a custom aluminum kick plate keeps the door looking clean and prevents damage to the frame and finish.

What a kick plate does on a busy door

The lower third of a door takes most of the abuse. Shoes, carts, delivery dollies and mop buckets strike it again and again, and over time the paint, anodized finish or glass edges start to chip and scratch.

A kick plate is a flat metal panel mounted on the push side of the door. It takes the impact instead of the door surface, so the door keeps its clean look for much longer and maintenance stays simple.

Why aluminum is a practical choice

Aluminum is light, does not rust, and suits aluminum doors well because it matches their frame and profile. It is easy to clean and can be supplied in a range of finishes to blend with the door.

Lightweight, so it does not add strain to hinges
Corrosion resistant for entrances exposed to weather
Easy to clean with routine wiping

Edge protection for heavy-use doors

Kick plates protect the face of the door, but the vertical edges and the leading corner also get knocked by trolleys and passing traffic. Edge guards or added protective profiles can be fitted along these areas to stop chips and dents.

Edge protection is especially useful on glass doors and thin-profile doors, where a single hard knock can cause real damage.

Sizing and fitting the kick plate

The height and width of a kick plate depend on the door, the type of traffic and how the door swings. Taller plates suit wheeled traffic, while lower plates may be enough for foot traffic only.

We measure on site before production so the plate fits the door exactly, leaves room for the handle and closer, and does not interfere with the swing. Exact dimensions are confirmed in the written specification before we begin.

Finish options and durability

Kick plates can be finished to match the door, which keeps the entrance looking coordinated. Options include anodized, powder-coated and brushed finishes, chosen according to how much wear the area will see.

For the strongest protection in demanding locations, a stainless steel kick plate is another option we can discuss with you, depending on the door and the environment.

How we work with you

The process starts with an inquiry and photos of the door. We then visit to measure, prepare a drawing and a written specification, and wait for your approval before anything goes into production.

Once approved, the plate is made in our factory, finished, and installed on site. This keeps the result accurate and avoids surprises at the entrance.

Frequently asked questions

What height should a kick plate be?

Height depends on the door and the traffic. Plates for trolley-heavy entrances are usually taller than those for foot traffic, and we confirm the exact height during the on-site measurement.

Can a kick plate be added to an existing aluminum door?

In many cases yes, as long as the door surface and mounting area allow it. We check the door on site and advise whether a plate can be fitted without affecting the swing or the closer.

Is aluminum or stainless steel better for a kick plate?

Aluminum is lightweight, corrosion resistant and suits most aluminum doors. Stainless steel offers extra strength for very demanding locations, and we can help you choose based on the traffic and environment.

Do you install the kick plates yourselves?

Yes. After production in our factory, we install the plates on site. Your approved written specification guides the work from start to finish.

Common mistakes to avoid

A common mistake is choosing a plate that is too short for the traffic, or fitting it without checking how the door swings and where the handle sits. Measuring on site first prevents both problems.

Our recommendation

For high-traffic entrances, choose a kick plate height that matches the wheeled traffic, not just foot traffic, and include edge protection on the leading corner. Confirm the dimensions in writing before production.

Summary

A kick plate aluminum door protects the most-used part of the entrance from scuffs and impact, and adding edge protection extends its life. Measure on site and approve a written specification to get a fit that works.

השאירו פרטים ונחזור אליכם