Custom Aluminum Fence Panels Sized to Your Property Line

t307-11

Custom aluminum fence panels are built to the exact length, height and angle of your property line rather than to standard sizes. For irregular or sloped boundaries, each panel is measured on site and manufactured to fit, so the fence follows the land instead of forcing the land to fit the fence.

Why Standard Fence Panels Often Don't Fit

Most ready-made fence panels assume a flat, straight boundary with uniform posts. Real properties rarely look like that. Corners may not be square, the boundary may bend around a tree or an old wall, and a slope can change the height of the fence from one end to the other.

When standard panels are forced onto these lines, gaps appear at the bottom, posts lean, and the gate may not close properly. Custom panels solve this problem from the start.

How the Measuring Visit Works

Before anything is built, we visit the property and take measurements along the full boundary. We record each run, the height at the high and low points, the position of existing posts, and any obstacles such as steps, drains or retaining walls.

Photos of the boundary and the surrounding area
Length and angle of each section
Ground level changes along the line
Notes on gates, pillars and access points

Designing Panels for Slopes and Stepped Ground

On a slope, there are two common approaches. Panels can be stepped so each section follows the ground in level steps, or they can be raked so the top rail follows the incline. The right choice depends on the look you want, the ground conditions and how the fence will be viewed from the street.

We provide a written specification and drawing that shows each panel, its dimensions and how it meets the next one, so you can review the design before production starts.

Materials and Finish

Aluminum is light, resists corrosion and needs little maintenance, which makes it a practical choice for boundary fences. Panel frames, infill bars and posts can be combined to suit privacy needs and the overall style of the building.

Finishing options include hot-dip galvanizing for steel components and powder coating for a durable colored surface. Your choice of finish is confirmed during the approval stage.

From Approval to Installation

Once you approve the drawing, panels are produced in our factory on Rival Street in Tel Aviv. Each piece is checked against the measurements before it leaves the workshop, which reduces adjustments on site.

Installation follows the layout from the measuring visit. Because the panels were built to your boundary, fitting is usually straightforward and the finished line looks deliberate rather than improvised.

Who Benefits Most from Custom Panels

Custom panels are especially useful for private homeowners with irregular plots, building committees with long shared boundaries, and contractors or architects working on sloped sites. They are also a good fit when a fence must match an existing gate, wall or design element.

If your boundary is straight and standard sizes already fit, a ready solution may be enough. Your measurements will show which approach makes sense.

Frequently asked questions

Do you measure the property before making the panels?

Yes. We visit the site, measure every section of the boundary and record slopes and obstacles. Production starts only after the drawing based on these measurements is approved.

Can aluminum fence panels follow a sloped boundary?

Yes. Panels can be stepped or raked to follow the ground. We confirm the method together with you based on the slope and the look you prefer.

Are aluminum panels strong enough for a property fence?

Aluminum is suitable for boundary fences when frames, posts and fixings are designed for the load and site conditions. Exact structural values are checked with the engineer for each project.

Can the fence include a gate that matches the panels?

Yes. Gates can be designed in the same profile and finish as the panels, and we plan their position during the measuring visit.

Common mistakes to avoid

A common mistake is ordering panels from a single measurement taken at one end of the boundary, which ignores changes in ground level and corner angles. Measure every section and check the height at both ends of each run before approving the design.

Our recommendation

Ask for a drawing that shows every panel and how it meets the next one before production begins. This simple step catches fit problems early and avoids costly corrections on site.

Summary

Custom aluminum fence panels are measured, designed and built for your exact boundary, including slopes and irregular lines. A careful site visit and an approved drawing lead to a fence that fits the land properly.

השאירו פרטים ונחזור אליכם