Request a Measured Quote for Your Parking Barrier Project

t460-39

To request a parking barrier quote from Techno Kol Uzi, send us photos and basic details of your entrance, then we arrange an on-site measurement. You receive a drawing and written specification for approval before any production starts.

Start with your inquiry

The quote process begins with a short inquiry. Tell us where the barrier will go, whether it is for a private driveway, a building entrance or a commercial lot, and how many vehicles pass through each day. Photos of the entrance, the surrounding walls and the existing ground make a big difference.

Also mention the power supply and whether you already have a control system or access cards. This helps us understand the full scope before we visit the site.

On-site measurement

After reviewing your inquiry, our team measures the opening on site. We check the clear width, the ground slope, the position of the pillar or base, and the space needed for the boom to swing without hitting a wall or a parked car.

Clear passage width and height
Ground levels and drainage
Power and cable routes
Access for delivery and installation

Drawing and written specification

Based on the measurement, we prepare a drawing and a written specification. The document covers the barrier type, boom length, materials, finish and the installation method. Anything that needs an engineer's check is marked clearly, so you know what is confirmed and what is still open.

Read the drawing carefully and ask questions before approving. Changes are much easier at this stage than after production.

Client approval

Once you approve the drawing and specification in writing, we lock the design and schedule production. Any later change to size, finish or layout may affect the work already planned, so it is worth confirming every detail now.

If you work with an architect, contractor or building committee, share the documents with them as well so that all decisions are made together.

Production and finishing

Production takes place in our factory on Rival Street in Tel Aviv, where we have been working in metal since 1945. Steel parts are cut, welded and assembled to your measurements. Finishing is done with hot-dip galvanizing or powder coating, depending on the exposure of the site and your preference.

Each component is checked against the approved drawing before it leaves the workshop.

Installation on site

Our installation team fixes the base, mounts the barrier and connects it to the power and control system. We test the movement of the boom, the safety sensors and the opening and closing cycle before handing over the barrier.

We also explain basic daily use and maintenance, so your staff or residents know how to operate the barrier safely.

Frequently asked questions

Do I need to be present for the on-site measurement?

It is helpful if you or a representative can be there, since you can point out access routes and any site limits. If that is not possible, send clear photos and any notes about the entrance.

How do I know the drawing is correct before production?

You receive a drawing and written specification that you must approve in writing. Review the dimensions, the barrier type and the finish, and ask us to clarify anything unclear before you sign off.

Can the barrier be changed after I approve it?

Changes are possible, but they are easiest before production starts. Once work is underway, any change must be reviewed again, which can affect the plan.

Who checks the safety requirements for the barrier?

We follow the relevant Israeli standards in general and confirm the exact requirements for your site with the engineer during the planning stage.

Common mistakes to avoid

Sending only a rough description without photos or measurements often leads to delays. Approving the drawing without checking the boom swing and the access width can cause problems after installation.

Our recommendation

Before you send your inquiry, measure the clear width of the entrance at its narrowest point and note the ground slope. Include a photo from the driver's position, since it shows the real conditions the barrier will face every day.

Summary

Send photos and basic details, arrange an on-site measurement, approve a written drawing, and then we produce and install your parking barrier in Tel Aviv.

השאירו פרטים ונחזור אליכם