Contact Us for Shop Parking Gate Installation in Tel Aviv

t284-42

For a shop parking gate installation, contact Techno Kol Uzi with photos of the entrance and a description of your space. We take measurements on site, prepare a written drawing and specification for your approval, then manufacture and install an electric sliding or swing gate built to fit your opening.

Why Shop Owners Choose a Custom Parking Gate

A shop parking area often has an unusual width, a sloped driveway or limited space for the gate to swing. Standard gates rarely fit these conditions well. A custom-made gate is designed around your exact opening, so it closes properly and looks consistent with your storefront.

We have been manufacturing iron, aluminum and steel work at our factory on Rival Street in Tel Aviv since 1945, and we build electric gates to measure for shops, offices and mixed-use buildings.

Sliding or Swing: Which Gate Suits Your Shop?

The right choice depends on the space available. Each option has clear strengths:

Sliding gates run along a track and need no clearance in front of the opening, which suits tight forecourts.
Swing gates open inward or outward and work well where there is room for the leaves to move freely.

During the site visit we check the ground, the wall construction and the traffic pattern, then recommend the option that works for your daily use.

What Happens During Our Site Measurement

Before any production starts, our team visits your shop to measure the opening, check level and verify where the motor, control box and power supply will go. We also look at drainage, nearby walls and the pedestrian path next to the gate.

Photos sent in advance help us plan the visit and sometimes let us prepare a preliminary design so the site meeting is faster and more productive.

From Drawing to Approval

After measuring, we prepare a drawing and a written specification covering the gate type, dimensions, materials, finish and automation. Nothing goes into production until you have reviewed and approved it.

This step lets you check details such as the infill pattern, the color and the position of the operating equipment before the work is made, which avoids changes later.

Manufacturing, Finishing and Installation

The gate is fabricated in our Tel Aviv workshop and finished with hot-dip galvanizing and powder coating for protection against weather and wear. Once ready, the gate is brought to your shop and installed, aligned and tested with the electric automation.

We check that the gate runs smoothly, that the safety sensors respond correctly and that the operator is set up for your everyday use.

Safety and Compliance Basics

Automated gates should include safety features such as photocells and obstacle detection. Railings and guards nearby should follow the Israeli standard SI 1142 where it applies. We discuss these requirements during the planning stage and confirm exact values with your engineer, so the installation fits both your building and the rules that apply to it.

Frequently asked questions

How do I start a shop parking gate installation request?

Send us photos of the entrance, a rough width and height, and a short description of how the gate will be used. We will reply to arrange an on-site measurement.

Do you measure on site before making the gate?

Yes. Every custom gate is measured at the installation location before production, so the final product fits the opening accurately.

Can you add automation to an existing manual gate?

In many cases yes, but it depends on the gate's condition, weight and structure. We assess this during the site visit and advise whether an upgrade or a new gate is the better choice.

Where is your factory located?

Our factory is at 37 Rival Street, Tel Aviv, where we manufacture all our gates, railings and metal works to measure.

Common mistakes to avoid

Many shop owners order a gate before measuring the space, leading to misfit openings or swing clearance problems. Confirm the layout on site before approving any drawing.

Our recommendation

Decide between a sliding and a swing gate early, based on the free space in front of the entrance, and make sure the power and control box position is agreed before production begins.

Summary

A shop parking gate installation works best when it starts with photos, an on-site measurement and an approved drawing. Contact Techno Kol Uzi to get a custom electric gate built for your shop.

השאירו פרטים ונחזור אליכם