Request an Office Gate Automation Proposal in Tel Aviv

t284-41

An office gate automation proposal is a written plan covering the gate type, motor, controls, safety devices and installation for your parking entrance. Techno Kol Uzi prepares it after photos and an on-site measurement, so the proposal fits your actual space and traffic.

What an Office Gate Automation Proposal Includes

A proposal is more than a quote. It describes the gate type, the operator, the control system and the safety devices, and it explains how the gate will be built and installed. For an office, it should also show how vehicles and pedestrians will enter and leave the site.

Gate type: sliding or swing, with dimensions
Motor and control unit
Remotes, keypad or access system
Safety sensors and loop detectors
Finish and installation steps

Ask for these points in writing so you can compare offers on equal terms.

Choosing Between Sliding and Swing Gates

A sliding gate suits offices where the entrance is wide and there is no room for a swing arc. It runs along a track and needs a clear path on one side. A swing gate suits narrower driveways where the space in front is free to open inward or outward.

The right choice depends on the site, the traffic flow and how often vehicles enter. Our team reviews these factors during the site visit and explains the options in the proposal.

What We Check During the Site Visit

Before drawing anything, we measure the opening, the ground slope, the surface for the track or posts, and the available power supply. We also note nearby walls, sidewalks and the street, since the gate must not block public space or interfere with neighbors.

Photos help us prepare, but the measurement on site is what the final drawing is based on. We confirm the approach and exit lanes and whether a pedestrian gate is needed.

Safety and Standards in Your Proposal

Automated gates must stop or reverse when they meet an obstacle. A good proposal lists the safety sensors, the photocells and the way the gate behaves during a power cut. For railings and pedestrian areas near the gate, we refer to the Israeli railing standard SI 1142 in general terms, and exact values are checked together with the engineer during design.

Ask the proposal to state which safety features are included and which are optional.

From Proposal to Installation

Once you approve the proposal, we produce the gate in our Tel Aviv factory at 37 Rival Street. The steel or aluminum frame is cut, welded and finished, with hot-dip galvanizing or powder coating where the site requires it. The motor and controls are fitted and tested in the workshop.

Then we install the gate on site, connect the power, set the limits and train your staff on daily use.

Preparing Your Request

To get a useful proposal, send clear photos of the entrance from both sides, the approximate width of the opening, and a short note on how many vehicles use it each day. Mention if you need a pedestrian door, an intercom or a access card system.

Photos of the entrance and street
Opening width and height
Daily traffic and users
Desired controls and access method

Frequently asked questions

How long does an office gate automation proposal take?

The proposal is prepared after the photos and the on-site measurement. Exact timing depends on the project and is confirmed when we receive your request.

Do I need to pay before receiving a proposal?

Please ask us directly about the proposal process. We will explain the next steps clearly when we respond to your inquiry.

Can you automate an existing gate?

In many cases yes, but the existing frame, posts and power supply must be checked on site first. The proposal will state whether the current gate can be automated or needs replacing.

Is a pedestrian gate included in the proposal?

It can be. Tell us in your request that you need a pedestrian access door, and we will include it in the drawing and specification.

Common mistakes to avoid

Many offices request a gate without giving the real opening width or the traffic pattern, which leads to a proposal that does not fit. Skipping the on-site measurement to save time often causes changes later.

Our recommendation

Before approving any proposal, confirm the safety devices, the behavior during a power cut and who is responsible for the final test. A written, measured proposal protects both the office and the installer.

Summary

A written office gate automation proposal, based on an on-site measurement, is the safest way to choose and install an electric parking gate.

השאירו פרטים ונחזור אליכם