Warehouse Gate Replacement: Inquiry and Site Visit Guide

t284-44

A warehouse gate replacement starts with an inquiry that includes photos of the existing gate and the opening, followed by an on-site measurement and a written specification. Electric sliding or swing gates are then manufactured to measure in our Tel Aviv factory and installed after your approval.

Why Warehouse Gates Need a Structured Replacement Process

A warehouse gate carries heavy daily use, trucks, forklifts and changing weather, so replacing it is more than picking a design from a catalog. The opening may be out of square, the surface may be uneven, and the drive mechanism must match the traffic your site handles. A structured process protects you from surprises on installation day.

At Techno Kol Uzi, every warehouse gate is built to measure. We look at how your site actually works before we propose a solution.

Step One: Sending Your Inquiry with Photos

Start by sending us clear photos of the current gate, the opening, the posts and the area around them. Include a wide shot that shows the approach for vehicles, since that determines whether a sliding or swing gate suits you better.

Photos of the gate and both sides of the opening
Approximate width and height if you know them
How often the gate opens and what vehicles pass through
Whether power and an access system are already on site

Step Two: The On-Site Measurement Visit

After reviewing your photos, our team visits the warehouse to measure the opening precisely. We check that the posts are plumb, the ground is level, and there is enough space for a sliding track or the swing arc of a leaf. We also note nearby obstacles such as drainage channels, curbs and parked vehicles.

The visit usually reveals details that photos cannot, and it is the basis for an accurate drawing.

Step Three: Drawing and Written Specification

Following the measurement, we prepare a drawing and a written specification covering dimensions, gate type, frame profile, infill, motor type, safety devices and finish. You review the document and can ask for changes before anything goes into production.

Clear specifications make it easier to compare options and avoid misunderstandings later.

Step Four: Production and Finishing in the Factory

Once you approve the specification, the gate is manufactured in our factory on Rival Street in Tel Aviv. Steel components are finished with hot-dip galvanizing and powder coating, which help the gate withstand outdoor conditions over the years.

Working in our own workshop lets us control quality at each stage, from cutting and welding to final inspection.

Step Five: Installation and Handover

On installation day, we remove the old gate, prepare the posts and mount the new gate and motor. We then test the operation, the safety sensors and any access controls together with you. Before we finish, we walk through how to operate the gate and what routine checks are useful.

Frequently asked questions

Do I need to send measurements before the site visit?

It helps but is not required. Photos and approximate dimensions let us prepare for the visit, and we take exact measurements on site.

Should I choose a sliding or swing gate for my warehouse?

It depends on available space and traffic. Sliding gates suit limited space in front of the opening, while swing gates suit areas with room for the leaves to open.

Is the old gate removed during installation?

Yes, we remove the existing gate as part of the replacement and prepare the posts for the new unit.

Can the new gate work with an existing access system?

In many cases yes. Share details of your current system in the inquiry so we can confirm compatibility during the site visit.

Common mistakes to avoid

Ordering a gate based only on the old opening without an on-site check often leads to wrong dimensions or an unsuitable drive. Skipping the written specification can also cause disagreements about finish and features.

Our recommendation

Measure the opening from the inside and outside, check that the posts are level, and note how the ground slopes before the inquiry. Ask for a written specification and review it carefully before approving production.

Summary

A warehouse gate replacement works best with a clear inquiry, a precise site visit, a written specification and factory-made quality. Techno Kol Uzi guides you through each step from Tel Aviv.

השאירו פרטים ונחזור אליכם