How We Produce Tempered Glass Vitrine Panels

t432-9

Tempered glass vitrine production starts with an accurate on-site measurement and a written drawing, followed by cutting, edge finishing and heat tempering of each panel. The finished glass is then fitted into aluminum or steel frames and installed on site. Each step is checked before the next one begins.

Measuring and Planning on Site

Every vitrine or glass partition begins with a visit to the location. We measure the opening at several points, because walls and floors are rarely perfectly straight. We also note where the display will stand, what lighting is planned, and how the doors or sliding parts will move.

Based on these measurements we prepare a drawing and a written specification. The client reviews it and confirms the details before any glass is cut.

Choosing the Glass and Frame

Not every display needs the same glass. We discuss thickness, clarity, edge style and whether the panels will be fixed or movable. Together with the frame material, these choices define how the vitrine looks and performs.

Glass thickness suited to the span and load
Clear or low-iron glass for maximum transparency
Frame in aluminum, iron or stainless steel

Cutting and Edge Finishing

Glass is cut to the approved drawing on precision equipment. Once cut, each edge is ground and polished so it is smooth and safe to handle. Holes for hinges, locks or supports are drilled before tempering, because tempered glass cannot be worked after heating.

Each piece is labeled so it can be matched with its position in the vitrine during assembly.

Heat Tempering

The cut and finished panels are heated in a furnace to a high temperature and then cooled rapidly. This process makes the glass considerably stronger than standard glass, and when it does break it shatters into small granular pieces rather than sharp shards.

After tempering, every panel is inspected for surface quality, edge condition and dimensions before it moves on to assembly.

Assembly in the Workshop

In our Tel Aviv workshop the tempered panels are fitted into their frames, hinges and handles are mounted, and the vitrine is dry-fitted to confirm that doors close smoothly and all parts align. Gaskets and seals are added where needed to keep dust out and the glass secure.

Doing this assembly in the workshop lets us catch and correct any issue before the piece leaves the factory.

Installation and Final Check

On installation day the assembled vitrine or partition is brought to the site and fixed in position. We level it, secure it to the floor or wall as required, and adjust the doors and fittings. Before we leave, we clean the glass and check that everything works as planned.

If you have questions about load or fixing methods, our engineer can advise, and exact safety values are confirmed with the engineer for each project.

Frequently asked questions

Can tempered glass be cut after it is made?

No. Tempered glass cannot be cut, drilled or edged after heating, so all cutting and holes must be completed before the tempering step.

Why is tempered glass used for vitrines?

It is significantly stronger than ordinary glass and, if it breaks, it crumbles into small pieces rather than sharp shards, which makes it a practical choice for display furniture and partitions.

How long does the process take?

Timing depends on the size and complexity of the piece and the current workload, so we confirm the schedule with you after the drawing is approved.

Do I need to be home during measurement?

It helps if someone can show us the location and answer questions about how the space will be used, but we will coordinate the visit with you in advance.

Common mistakes to avoid

A common mistake is ordering glass before the opening has been measured accurately on site. Changing dimensions after tempering is not possible, so always confirm the drawing first.

Our recommendation

Before approving the drawing, check door swing, lighting position and access for cleaning, because these details are much harder to change once the panels are made.

Summary

Tempered glass vitrines are made through careful measuring, cutting, finishing, tempering, assembly and installation, with a check at every stage.

השאירו פרטים ונחזור אליכם