Custom Metal Pivot Doors Made to Architectural Specifications

t503-14

A custom metal pivot door is a heavy door that rotates on top and bottom pivot points instead of hinges, suited to large openings and high-traffic entrances. Techno Kol Uzi manufactures these doors to architectural drawings in iron, aluminum or stainless steel, with the pivot assembly engineered for the door's weight and the building's use.

When a pivot door is the right choice

Pivot doors suit entrances where a conventional hinged door would be too heavy, too wide or too visually bulky. Architects often specify them for lobbies, villas with glass-and-steel facades, and interior feature doors that need a dramatic sense of scale.

Because the door carries its weight on the pivot rather than on side hinges, it can be made taller and heavier while still opening smoothly. The choice of material, frame profile and glazing should be settled early, since each affects the weight and the pivot design.

What we need from your drawings

To manufacture to specification, we work from your plans and sections. The most useful information includes:

Clear opening dimensions and the required door leaf size
Pivot axis position and the floor finish at the threshold
Material and finish, such as hot-dip galvanizing or powder coating
Glazing type and infill, if any
Direction of swing and required locking points

Where details are unclear, we raise questions before production begins.

Engineering the pivot and frame

The pivot set and the head and sill brackets carry the full load of the leaf, so they are sized for the actual weight and the opening's span. We do not rely on rules of thumb. Load paths, anchoring into the structure and the clearance needed for smooth movement are checked against the engineer's requirements.

Frame sections are chosen for stiffness, so the door stays flat and does not sag over years of daily use.

Materials and finishing

Steel suits heavy entrances and offers strength with a robust, industrial character. Aluminum brings lighter weight for larger leaves. Stainless steel works well in exposed or humid settings. Each can be finished by hot-dip galvanizing for corrosion protection or powder coating in the colour your architect specifies.

The finish should match the environment: a sheltered interior door has different needs from a door facing the sea air.

From drawing to installation

Our process follows a clear sequence: an inquiry with photos or drawings, on-site measurement, a written specification for your approval, production in our factory, finishing, and then installation. Measuring on site before fabrication reduces the risk of a leaf that does not fit the opening as built.

You receive a specification you can check against your design intent before any metal is cut.

Coordinating with architects and contractors

We regularly work alongside architects, interior designers and contractors. Sharing tolerances, floor build-up and wall finishes early avoids conflicts on site. We can coordinate the pivot position with the structural drawings, and we can adjust detailing to suit the architectural language of the project.

Clear communication at the specification stage is the best way to keep a pivot door on schedule and on the intended design.

Frequently asked questions

What materials can a custom metal pivot door be made from?

We manufacture pivot doors in iron, aluminum and stainless steel. The best choice depends on weight, exposure to weather and the finish your design calls for.

Do you install the doors as well as make them?

Yes, installation is part of our process after production and finishing. We confirm measurements on site before fabrication to ensure a proper fit.

Can pivot doors include glass?

Yes, glazed infills can be incorporated into the steel or aluminum frame. The glazing type is specified early because it affects the door's total weight and pivot design.

How do I start a project with you?

Send us photos or drawings of the opening, and we will arrange on-site measurement and prepare a written specification for your approval.

Common mistakes to avoid

A common error is specifying a heavy leaf without confirming the pivot load and anchoring in the structure. Leaving the threshold and floor finish undecided until late also causes fit problems.

Our recommendation

Fix the pivot axis, floor build-up and finish at the drawing stage, and have the leaf weight checked against the structure before approving the design.

Summary

Custom metal pivot doors are a strong solution for large, heavy or feature entrances when they are specified and measured carefully from the start.

השאירו פרטים ונחזור אליכם