Inspecting a Finished Door Before Delivery at Techno Kol Uzi

t418-21

Inspect a finished door before delivery by checking dimensions against the approved drawing, the surface finish, welds or corners, hardware operation and the frame fit. Doing this at the factory, before the door leaves for installation, makes it far easier to request corrections while the piece is still in production.

Why Inspect Before the Door Leaves the Factory

A custom iron or aluminum door is made to your measurements, so every detail matters. Checking the finished piece before it is delivered and installed saves time and avoids disputes on site. Small issues are simpler to correct in the workshop than after the door is fixed into a wall.

Bring your approved drawing and written specification to the inspection. Compare them point by point with the door in front of you, so nothing is left to memory.

Check Dimensions and Opening Fit

Confirm that the overall width, height and frame depth match the measurements taken on site and recorded in the specification. Check the opening direction, the side the handle is on and the swing, since these are easy to mix up.

Diagonal measurements should be equal for a square-true frame.
The door should sit square and plumb without forcing.

Any question about tolerances should be settled with the engineer, who will confirm the exact values.

Inspect the Surface Finish

For galvanized or powder-coated doors, look for an even colour and gloss across all faces, including the edges and inside corners where coating often runs thin. Check for drips, pinholes, scratches or dust trapped in the coating.

Aluminum doors should show consistent colour and smooth profiles without dents or marks from handling. Ask for corrections before the door is wrapped for transport.

Examine Welds, Corners and Hardware

Run your hand along welded joints and look for sharp spots, gaps or uneven beads that could catch clothing or affect the finish. Check that every corner closes neatly and that infill panels or glass are seated correctly.

Test the hinges, locks, handles and any closer. The door should latch smoothly, the lock should turn without catching and the hardware should be fixed securely.

Test Operation and Alignment

Open and close the door several times in the workshop. It should move freely, stay where you leave it and close without rubbing on the frame. Check the gaps around the edges; they should be even on all sides.

Look for sagging or twisting when the door is opened fully.
Confirm that any security features or locking points work as specified.

Plan Delivery Day and Installation

Before delivery, clear the path, confirm the opening is ready and make sure the wall, floor and frame are prepared as agreed. Arrange for someone to be present to sign the delivery note and accept the door once you are satisfied.

Keep photos of the inspection and your signed approval. If a correction is needed, record it on the delivery note so that installation proceeds with a clear, agreed result.

Frequently asked questions

When is the best time to inspect a door?

The best time is at the factory, after production and finishing but before the door is packed for transport. Issues found there are much easier to correct.

What should I bring to the inspection?

Bring your approved drawing and written specification, along with any photos taken during measurement. This lets you compare the finished door against the agreed details.

Can I refuse a door that has a minor scratch?

Small cosmetic marks should be discussed with the factory before you accept delivery. Note any issue on the delivery paperwork so it can be addressed clearly.

Do I need to check the door again after installation?

Yes, a quick check after fitting confirms that the door swings, latches and seals properly within the actual opening. Report any problems to the installer promptly.

Common mistakes to avoid

Many customers skip the inspection and only notice a wrong opening direction or a faulty lock after installation. Accepting the delivery without checking it against the drawing often leads to avoidable delays.

Our recommendation

Inspect the door with the approved drawing in hand, operate the hardware several times and note every correction on the delivery paperwork before signing.

Summary

A careful inspection before delivery confirms dimensions, finish, hardware and alignment, so your door installs smoothly the first time.

השאירו פרטים ונחזור אליכם